90
Expert Tip: Mounting the governor to the counter gear instead of the fan
BPS-1
RPM Sensor which attaches a sensor to an exclusive engine
directly is simpler.
Governor Speed
Switch Position
(Switch C
Rate (%)
UP
or
NORM 0
RS2: 1400
CNTR
or
IDL1 50
Speed adjusted by raising and lowering rate.
RS3: 1700
DOWN
or
IDL2 100
Speed adjusted by lowering rate.
*The relationship of the governor speed setting rS1~rS3 and the switch positions conforms to the table above.
*If the speed value rises when the cut switch is activated, reverse the “
DIR
UP
to
DOWN
or vice versa.
GOAL of EXAMPLE: STEPS: INPUTS:
both channels into the receiver
and switch between the governor
settings automatically when changing
conditions. Consider setting the battery
Open and activate the
GOVERNOR
function.
for 1 second.
to
GOVERNOR
.
Activate the function.
to
MIX
. to
CH7
.
MIX
to
CH7
.
SW
. to desired
SWITCH.
Ex: select switch that adjusts the
to
MODE
.
to
Cond
.
Adjust governor speed settings per
switch position or condition as needed.
(Ex: defaults are fine.) Allows head
speed adjustment from transmitter.
to each
Cond
position.
or as needed.
to next
Cond
position. Repeat.
Close the function.
Where next?
GYRO
: see p. 87.
F/S
) settings (p. 48).
See p. 78.
Adjust elevator/aileron response to fit your flying style: see
D/R
,
EXP
and
END
POINT
/
SWASH AFR
: p. 39, 36, 75.
To Next Page
Loading...
