69
GOAL of EXAMPLE: STEPS: INPUTS:
Set up a
RUDD-ELEV
curve mix on a
model that pitches down severely at
full rudder and not at all with minimal
rudder input, and pitches worse on right
rudder than left:
P-1: 25%
P-2: 8%
P-3: 0%
P-4: 10%
P-5: 28%
ON
when SWITCH C is down.
elevator would be retrimmed when the
mix is active and no rudder input is
given.)
Open an unused curve programmable
mix. (Ex: use
PROG.MIX6
since it is
RUDDER-ELEV
.)
for 1 second.
to
P.MIX1-6
.
to
6
.
Activate the function.
to
MIX
. to
ON
.
Choose master and slave channels.
(Ex: do not change
MAS
or
SLV
).
already
RUDD
already
ELEV
Assign SWITCH and position.
(Ex: change to
C
,
DOWN
.)
to
SW
. to
C
.
to
POSI
. to
DOWN
.
Optional: set switch to
THR
to activate
mix with THROTTLE STICK. (See
above for details.)
to
SW
. to
THR
.
to
POSI
.
THROTTLE STICK to desired
point.
for 1 second to set.
Optional: set switch position to
NULL
THR
to
POSI
. to
NULL
.
(Ex: listed at left.)
to
P-1
. to
25%
.
Close menu.
Where next? Adjust servo
END POINTs
: see p. 36.
Set up
AILEVATOR
: see p. 54.
To Next Page
Loading...
