41
GOAL of EXAMPLE: STEPS: INPUTS:
Set up aileron triple rates on SWITCH
C
aerobatics) and exponential settings of
ACRO
model.
NOTE: This normal rate has no
exponential so it has a very linear,
normal feel. This slow roll rate has
positive exponential (the opposite of
what most people normally use), which
feel the same around center in the
normal and low rates, but still gives a
The 3D rate (extreme aerobatics) has a
very high distance of travel nearly twice
that of the normal rate. Therefore, using
a very high negative exponential setting
softens how the servos respond around
for a more comfortable feel.
switch. To do so, simply set up rates
for all 3 controls and assign all 3 to the
Open
D/R
,
EXP
function.
for 1 second.
to
D/R
,
EXP
.
Choose the channel to change
(Ex: aileron is already selected)
to desired channel.
to
SW
. to
SwC
.
Confirm switch is in desired position
to
D/R
.
C to up position.
AILERON STICK.
AILERON STICK.
Move SWITCH to 2nd rate position and
set this particular rate.
C to center position.
AILERON STICK.
AILERON STICK.
C to down position.
AILERON STICK
.
AILERON STICK
.
EXP
.
to
EXP
.
C to up position.
EXP
reads 0.
C to down position.
AILERON STICK
.
AILERON STICK
.
C to center position.
Close.
Where next?
Set up
TRAINER
functions: see p. 44.
Adjust the sensitivity of the trims: see p. 45.
Set up twin aileron servos: see p. 52.
Set up twin elevator servos: see p. 54.
To Next Page
Loading...
