63
Throttle delay function
THR-DELAY
(
ACRO
):
The
THR-DELAY
function is used to slow the response of the throttle servo to
simulate the slow response of a turbine engine. A
40%
delay setting corresponds
100%
DELAYS
, p. 84.
THR
), throttle into an auxiliary channel such as 8, and then using
GOAL of EXAMPLE: STEPS: INPUTS:
Activate
THR-DELAY
Slow the servo response by one second.
Open the
THR-DELAY
function.
for 1 second.
to
THR-DELAY
.
Activate the function.
to
MIX
. to
ACT
.
Adjust the
RATE
to match the desired
servo speed. (Ex:
40%
.)
to
RATE
. to
40%
.
Close menu.
Where next? Set up
THROTTLE-NEEDLE
mixing: see p. 62.
END POINT
: see p. 36.
Adjust throttle exponential (
D/R
,
EXP
): see p. 39.
Set up
AILEVATOR
: see p. 54.
Set up programmable mixes, for example,
RUDDER-AILERON
: see p. 65.
Where next? Set up
THROTTLE DELAY
Adjust throttle and Ch8
END POINTs
: see p. 36.
Set up programmable mixes, for example,
AILERON-to-RUDDER
: see p. 65.
To Next Page
Loading...
