65
LINEAR PROGRAMMABLE MIXES (
PROG.MIX1-4
):
Adjustability:
these mixes, simply select that mix number so that the master and slave servos are already selected for you.
PROG.MIX1
PROG.MIX2
HELI
PROG.MIX3
HELI
PROG.MIX4
also be set to the master channels. (see below.)
the controlling channel. The channel whose movement is followed by the slave channel.
Another channel:
coupling.)
MASTER TRIM POSITION RATE
RUDD AIL OFF
ANY
NULL 25% 0
To create an
OFFSET
when SWITCH C is in down position.)
MASTER TRIM POSITION RATE
OFS FLP
N/A
C DOWN 20%
N/A
(Ex: create a second throttle trim on DT6 lever.)
MASTER TRIM POSITION RATE
DT6 THR
N/A ANY
NULL 5%
N/A
the controlled channel. The channel that is moved automatically in response to the movement of the master
With
TRIM OFF
, rudder trim would bind the two servos.
TRIM ON
resolves this.
Your 8J contains four separate linear programmable mixes. (Note that P.Mixing
There are a variety of reasons you might want to use these mixes. A few are
setup follows, step by step, to assist you.
To Next Page
Loading...
