FUTABA 8J - Delay Function for Smooth Transitions; Applying Delay to Channel Transitions

84
DELAY
: The Delay function provides a smooth transition between the trim positions whenever
OFFSET
,
REVO. MIXING
, or
THROTTLE HOLD
functions are turned on and off.
Adjustability:
         
pitch.

new position...quite a long time.

GOAL of EXAMPLE: STEPS: INPUTS:
Set up a delay on all channels to ease
     
to another so there are no "hard jumps."
Open the
DELAY
function.
for 1 second.
to
DELAY
.
Adjust
AILE
response as needed. (Ex:
aileron to
+8%
.)
to
+8%
.
Repeat for other channels.
to
ELEV
. Repeat step above.
Close menus and confirm slowed
transitions.
EG (T8JA) from
NORMAL
to
IDL2

move gradually to new positions.
Where next?
THR-HOLD
: see p. 80.

(
THR-CURVE, PIT-CURVE, REVO. MIX
