49
Cond
From 3/5
Go to 5/5 from any
cursor position
(9) PIT. Rate: Rate adjustment
The [PIT.Rate] is the amount of collective pitch travel allowed. A good
starting range for Sport, 3D and F3C is +/-10 to +/-12 degrees. Use the [
/+] or [ /-] key
to make an adjustment.
Setting ranges: 0 ~ 100 Initial value: 50%
(10) SWS. Ring
This parameter is used to set the total maximum of
cyclic throw as well as limit the swash travel to prevent
binding of the swash plate servos when the control stick
is moved toward a corner (for example, full right and full
aft cyclic). Press the [
/+] or [ /-] key
to adjust the value.
Setting ranges: 50 ~ 100% Initial value: 130%
(11)
AGy. Dir: Aileron (roll) Gyro direction
EGy. Dir: Elevator (Pitch) Gyro direction
This parameter controls which direction the CGY760R
(roll / pitch axis) will compensate when the helicopter
rolls (pitches). Pick the helicopter up and roll the heli
-
copter to the right. The CGY760R should compensate
by adding left cyclic to the swash plate. (Pick the heli
-
copter up and rotate the nose of the helicopter down-
ward. The CGY760R should compensate by adding aft
cyclic to the swash plate.)
If the CGY760R compensates in the wrong direction,
then it will be necessary to reverse the compensation
direction setting by pressing the
[
/+] or [ /-]
key once.
SWH. BASIC screen 4/5
WARNING
Verify that the CGY760R compensates in the correct direction
before flight. If the compensation direction is incorrect the model
will roll or pitch uncontrollably even before it leaves the ground.