EasyManuals Logo

FUTABA GPB-1 Instruction Manual

FUTABA GPB-1
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #73 background imageLoading...
Page #73 background image
73
R
UD.
E
XPERT
M
ENU (RUDDER GYRO EXPERT SETTING)
7KHUXGGHU ([SHUW PHQX DOORZVIRUIXUWKHUUH¿QHPHQW RI WKHWDLOURWRUJ\URSHUIRU-
PDQFH5HIHUWRSDJHDQGVHOHFWWKH
"
58'(;3(57
"
screen from the
"
(;3(57
0(18'
"
VFUHHQ
(1) RUD Ntr:
Rudder servo neutral setting
This parameter is used to set the neutral position of the rudder servo. Po-
sition the rudder servo arm as perpendicular as possible to the tail rotor
pushrod prior to making adjustments with this parameter. Move the cursor
to "RUD Ntr" with the [
/+] or [ /-] key and press the [Enter] key to enter the
setting mode. Adjust the neutral position with the [
/+] or [ /-] key. When
you finish adjusting, press [Enter] key to exit setting mode.
Setting ranges: -240 ~ 0 +240 Initial value: 0
(2) EXP. AVCS / EXP. NORM:
Rudder exponential
This parameter sets the feel of the tail rotor control around center. When
set to [0] the control curve is linear. Using a [+] value the tail rotor will be
more sensitive around neutral conversely, using a [-] value will soften the
feeling around neutral. The RUD EXP parameter in your transmitter can
also be used to tune the tail rotor to a desired feeling.
Setting ranges: -100 ~ 0 +100% Initial value: AVCS = -20% , NORM = -20%
Sports = AVCS -60% / NORMAL -40%, 3D = AVCS -20% / NORMAL -20%>
From 5/5
From the "Sens. Model" of
RUD. EXPERT screen 5/5
Go to 2/5 from any
cursor position
RUD. EXPERT screen 1/5
: :
:

Other manuals for FUTABA GPB-1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FUTABA GPB-1 and is the answer not in the manual?

FUTABA GPB-1 Specifications

General IconGeneral
BrandFUTABA
ModelGPB-1
CategoryScience Education products
LanguageEnglish