G-Technology G-RAID Studio - RAID Configuration Utility for Windows; Configure RAID Mode for Windows

Using RAID Modes
p.26
RAID Conguration Utility for Windows
The G-Technology RAID Congurator is used to change the RAID level of your G-RAID
Studio. You can use any of the two Thunderbolt 2 ports in your G-RAID Studio with the
RAID Congurator application. To congure G-RAID Studio, it will need to be the only
device connected to your computer.
The RAID Congurator utility is available for download from the G-Technology website
at g-technology.com/support.
Once you have downloaded the RAID Congurator .zip le you need to extract the
folder which contains the RAID conguration .exe le and a .dll le. Click on the .exe le
and follow the simple instructions to install the conguration utility.
Once you install and launch the RAID Conguration Utility the tool shows the current
status and other details of the drive similar to the diagram below.
Congure the RAID Mode for Windows
You can easily congure G-RAID Studio’s RAID mode with the following steps.
Important Note: Changing the RAID level will erase all data on the drive. Be sure all of
the data and les you want to save are backed up to separate media.
1. In the G-RAID Studio Conguration Utility, click on the Congure button. A dialog
window will pop up with three options for conguring your disk set, as shown
below. The dialog window also will warn you that when you congure your RAID set,
all data in the drive will be erased.