4. Operating System and Equipment
Seat/Exterior Rear-View Mirror Memory System*
Seat memory switch
1. "SET" button
2. "Position 1" Button
3. "Position 2" Button
4. "Position 3" Button
Caution
The seat refers to the driver's seat, and other
seats are not provided with the memory function.
Position Saving
1. Adjust the seat and the exterior rear-view
mirror surface position.
2. Press the "SET" button.
3. Release the "SET" button, and press the
position button 1/2/3 within 3s. The instrument
cluster will give a "click" to tell that the current
seat and exterior rear-view mirror surface
position are saved successfully.
Position Extraction
1. Convenient Extraction
– When the ignition switch is at "OFF" or "ACC"
position and the position button 1/2/3 is short
pressed, corresponding position information
can be extracted.
2. Normal Extraction
– When the Ignition switch is at “ON” position
and the gearshift lever of the transmission is
at other positions except “P” position, long
press any one position button of 1/2/3 to
extract the corresponding position information.
If the position button is released during the
extraction, the extraction will be interrupted
immediately.
The extraction will be interrupted immediately
if the seat adjustment switch is
pressed again
during the extraction, and if the seat adjustment
switch or the seat memory switch is pressed during
normal extraction.
108
To Next Page
Loading...
