5. Driving Directions
• After the vehicle is parked steadily, apply the
EPB first.
•
Applying the EPB may generate running
noise, which is a normal phenomenon.
• If the vehicle is used to pull other vehicles
or
is parked on a ramp with larger slope, pull the
EPB system button again after the completion
of first application of EPB to ensure the
maximum parking force.
•
On the slope of 17 ~ 30 %, a clamping will be
performed again 5 minutes later upon the first
application of the EPB. A certain noise is
normal at this moment.
Caution
• The EPB must be applied when parking.
•
When the vehicle is in driving process, it is not
allowable to decrease the speed by using
EPB when unnecessary, because the parking
brake only exerts power on the rear wheels,
which can easily cause traffic accidents.
Releasing Static Parking Brake
– Press the brake pedal when the ignition switch
is at the “ON” position.
– Press the EPB system button ① until the
button indicator light and the indicator light
on the instrument cluster are off, which
indicates that the EPB has been released.
172
To Next Page
Loading...
