5. Driving Directions
• If the brake pedal is not depressed, the EPB
will not be released by pressing the EPB
system button, the buzzer will raise an alarm,
and the instrument cluster display will prompt
"please depress the brake and release the
EPB".
• Releasing the EPB may generate running
noise, which is a normal phenomenon.
• In case of low battery, the EPB cannot be
released. Conduct the emergency start
through bridging the cable if allowable (=>
Refer to Page 303), and then release the
EPB. Please contact your authorized GAC
Motor's dealer for handling.
• If the EPB is not applied for a long time, the
system will detect the conditions automatically
with audible running noise.
Applying Dynamic Emergency Brake
– If the ser
vice brake fails during driving, try to
lift up the EPB system button ① continuously
for an emergency braking. Release the EPB
system button or press the brake pedal to exit
from the emergency braking.
Caution
In case of any of the following phenomena,
please operate the EPB again. If the fault
persists, please go to any authorized GAC
Motor's dealer for maintenance.
• If the indicator light
flashes in red
continuously, it indicates that the EPB is in
partial combination/ removal state or there is a
fault in the system.
• If the indicator light lights up in re
d when
the EPB is not applied, the system is
abnormal.
• If the indicator light
(yellow) is on, it
indicates that a fault is detected in the EPB
system and the EPB performance decreases.
173
To Next Page
Loading...
