Galcon DCS Series User Manual

Programming Options
15
4 . Additional Programming Options
4 . 1 . One-Time Irrigation
This option is used to program the
irrigation controller to operate the
irrigation system one time only, for the
irrigation period as set in Section 3.3.
1 . Press
until appears.
2 . Press
a number of times (for all
the days of the week) until
appears, and blinks on the
display.
3 . Go to Section 4.3 to set the start
time day and time.
4 . 2 . Cyclical Irrigation
This option is used to program the
irrigation controller to operate the
irrigation system in a cyclical manner,
once every x minutes, hours or days,
for the irrigation period as set in
Section 3.3.
1 . Press
until appears.
2 . Press
a number of times (for all
the days of the week) until
appears, and blinks on the
display.
3 . With the display blinking, press
or . The word “every” appears on
the display. The number of hours
and minutes in the cycle period
appear below the word “enter”.
4 . Set the desired irrigation operation
frequency in minutes, hours or days
by pressing
or -first minutes,
next hours and then days.
* When the irrigation operation
frequency exceeds 23 hours, the
word “days” appears, above
which the number of days
between irrigation operations
appears. For example, if the
irrigation operation frequency is
2 days, irrigation will take place
once every two days, for the set
irrigation period.

Galcon DCS Series Specifications

General

Brand	Galcon
Model	DCS Series
Category	Irrigation System
Language	English