Galcon S Series Installation And Operating Instructions

3.7 Example: Programming a Weekly Irrigation Schedule
Let's assume you want to program the irrigation controller to water
three times a day using the 24 hour time display format: at 08:00 AM,
13:00 PM and 19:00 PM, for 21/2 hours at a time, on Tuesday and
Friday.
To switch to an AM/PM time display format, see section 3.2.
(If you are using a DC-1 model irrigation controller, start from step 4.)
1. Press © until & appears.
. Press ®©. A blinking arrow appears at the bottom of the display.
. Press ® or © to move the arrow to the number of valve to be
programmed.
Press © until X appears.
. Press ®© . The hour digits blink. Press ® or © until the hour displays
. Press ©. The minute digits blink. Press ® or © until the
minute displays 30.
. Press ©. appears.
. Press ®. A blinking ¥ appears at the top of the display, under
Monday. Press & until the blinking arrow appears under Tuesday,
and then press ®. The arrow under Tuesday will stop blinking and
advance one position to the right, to Wednesday. Press © twice
to move the arrow to Friday, and then press @ .
8. Press ©. START | time appears. Press ®©. The hour digits blink.
9. Set the start time to 08:00 by pressing ® or ©.
Repeat this step to set START II time [ 2] to 13:00 and START III
time [ 3] to 19:00.
10. Press ©. START IV time [ 4] appears. Press ®©. The hour
digits blink.
11. Press ® or © until IFF appears. The fourth opening of the valve
is canceled.
NO NOOK ON
13

Galcon S Series Specifications

General

Brand	Galcon
Model	S Series
Category	Controller
Language	English