Galcon S Series Installation And Operating Instructions

4.5 Opening an Irrigation Window after Start Time has passed
Example: You are setting an irrigation program specifying 5 minutes of irrigation every
30 minutes, from 9:00 AM to 5:00 PM. However, you have entered the settings at
9:20 AM. As a result, the program will not commence today, but only from 9:00 AM
tomorrow. To force the program to begin today, perform the following steps:
1. Press © until START | is displayed.
2. Press ® and © to set any time after the current time: e.g. 9:30 AM. This time will
constitute the first start time for today. From tomorrow, the schedule will operate
according to the program you set. The Start | display will display the next start time
taking into account the window you have set.
4.6 Example: Programming a Cyclical Irrigation Schedule
Let's assume you want to program the irrigation controller to open the valve at 12:45
PM, for a period of one hour, every 5 days.
1. Set the irrigation duration as described in Section 3.4: Setting the Irrigation Duration.
(Press © until X appears, then set the desired irrigation duration by pressing
® and © ).
2. Press © until SS appears.
3. Press ©) a number of times (for all the days of the week) until On CE appears blinking
on the display.
4. While the display is still blinking, press or until "5 days" appears on the display,
representing the irrigation frequency.
. Press ©. START | is displayed.
. Press ®©. The hours digits blink.
Press ® until the hours digits change to 12 (PM).
. Press © until the minute digits change to 45.
ONO OH
17

Galcon S Series Specifications

General

Brand	Galcon
Model	S Series
Category	Controller
Language	English