Galcon S Series Installation And Operating Instructions

6. Maintenance, Troubleshooting and Repairs
°. Batteries should be removed if the irrigation controller is not going to be used for a
lengthy period.
° A filter must be installed upstream of the valve or system of valves and cleaned every
few months. Operation without a filter is liable to lead to malfunctions.
e Under normal usage, batteries (Alkaline) last at least a year.
e Do not run water through an irrigation line unless a solenoid is fitted on the hydraulic
valve.
e Recommended water pressure: 1-8 ATM (bar).
Problemvevent | Cause J somon |
Valve does not open during Valve handle not in Move valve handle to
Automatic operation or during AUTO position. AUTO position.
"Manual" operation via irrigatio , ;
a Batteries not working Replace batteries
controller
No display Batteries not working Replace batteries
Valve does not close, despite Valve handle not in Move valve handle to
click heard during activation AUTO position. AUTO position
Dirt and scale in valve mechanism Clean or replace valve
5 mm seal (O-Ring) between Install new seal (O-Ring)
bayonet adapter and valve
missing (See illustration below)
Water
leak
from
the
20
mm
seal
(O-Ring)
between
|
Install
a
new
seal
(O-Ring)
solenoid-valve
coupling
bayonet
adapter
and
valve
connection
missing
(See
illustration
below)
1. 20 mm seal (O-Ring).
2. 5 mm seal (O-Ring).
24

Galcon S Series Specifications

General

Brand	Galcon
Model	S Series
Category	Controller
Language	English