Page 23 of 35 GTLE Error list GTLE Operating Manual
Message-
number
Sensor-/
actuator
Messagetext Reason Action
6 - no charging
The stair lift is not at the stop.
The charging cycle was interrupted.
The load fuse has fallen.
Take the stairlift to the charging station. Check the charger to
see if the LED light is green or orange. If the LED does not light
up and the error message does not go away, the charging cycle
is interrupted. Contact your service technician.
7 - no charging, battery empty
Batteries are close to deep discharge. Shortly after
this message appears, the lift automatically
switches to standby and operation is no longer
Wake up the lift from standby by pressing the S1 button. Drive
the stairlift into the charging station and charge the batteries. If
this does not help, the batteries are damaged and must be
8 S27 Overload (S27) There is too much load on the platform. Reduce the load on the platform. The lift will not start.
9 K0 Contactor error K0
Feedback from contactor K0 does not match the
Error on the power board. Switch the lift off and on again. If the
error persists, contact your service technician
10 K1 Contactor error K1
Feedback from contactor K1 does not match the
control.
Error on the power board. Switch the lift off and on again. If the
error persists, contact your service technician
11 S30/K30 Sensor S30 always activated
Sensor S30 has also switched outside the stop or
the relay K30 is defective.
Check the sensor distance to see whether it still strikes outside
12 S31/K31 Sensor S31 always activated
Sensor S31 has also switched outside the stop or
the relay K31 is defective.
Check the sensor distance to see whether it still strikes outside
13 - two stops activated Two stops are operated at the same time.
Checking whether a stop sensor is stuck or a sensor constantly
14 A2 error at motor controller (A2) There is a fault in the motor controller.
Check the connections at the motor controller to see if a plug is
loose there.
To Next Page
Loading...