GANSER LIFTSYSTEME GTLE - Page 38

GTLE Operating Manual Maintenance manual Page 33 of 35
Lfd.
Nr.
Work to be carried out
(Only by qualified technician)
Equipment / Materials W1 W2 Comments
3.6.2
Check function, fastening, adjustment (folded up and down),
lubricate bearings.
S1 / S2 / S3
☐
☐
3.6.3
Check the preservation of bearings and moving parts, spray the
areas with preservative if necessary.
K2
☐
3.7
Electrical, electronic components and wiring
3.7.1
Check for tight fit and clean off dirt
K4
☐
☐
3.7.2
Check connectors for corrosion, conserve if necessary.
K3 / K4
☐
3.8
Cable drum
If present
3.8.1
Check for corrosion, noise, wear and deformation.
☐
☐
3.8.2
Check function, tight fit, guidance and lubrication
S1 / S2 / S3
☐
☐
3.9
Operating limit switch, emergency limit switch, safety switch, main
3.9.1
Look for break-outs, wear and dirt
☐
☐
3.9.2
Check function, adjustment and fastening
☐
☐
3.10
Internal control
3.10.1
Check function and fastening
☐
☐
3.10.2
Search for break-outs and missing labelling
☐
☐
3.11
Folding seat / seat belt
If present
3.11.1
Check for chipping, cracks and deformation
☐
☐
3.11.2
Check function and fastening and lubricate bearing points
S1 / S2 / S3
☐
☐
3.11.3
Check the preservation of bearings and moving parts, spray the
areas with preservative if necessary.
K2
☐
3.12
Casing and frame parts
3.12.1
Check the internal housing parts, frame parts and frame parts screw
connections for tight fit and corrosion.
☐
☐
3.12.2
Check the preservation of the internal housing parts, frame parts and
frame part screw connections, if necessary spray the areas with
K1 / K2
☐
3.13
Emergency crank