GANSER LIFTSYSTEME GTLE - Page 37

Page
32 of 35 Maintenance manual GTLE Operating Manual
Lfd.
Nr.
Work to be carried out
(Only by qualified technician)
Equipment / Materials W1 W2 Comments
3.1.6
Check the preservation of the bearings and moving parts, if
necessary spray the areas with preservative.
K2
☐
3.2
Drive unit
3.2.1
Check for corrosion, chipping, noise, wear and deformation.
☐
☐
3.2.2
Check adjustment, function and tight fit and lubricate bearings.
S1 / S2 / S3
☐
☐
3.2.3
Check for leaks in worm gears
☐
☐
3.2.4
Check preservation of bearings and moving parts, spray areas with
preservative if necessary.
K2
☐
3.3
Safety gear
3.3.1
Check for corrosion, chipping, noise, wear and deformation.
☐
☐
3.3.2
Check adjustment, tight fit and ease of movement of moving parts.
☐
☐
3.4
Safety barriers
3.4.1
Check position, function, play and lubricate bearing points
S1 / S2 / S3
☐
☐
3.4.2
Check for corrosion, noise and contamination
R1
☐
☐
3.4.3
Check function and tight fit of barrier motor
☐
☐
3.4.4
Check function of slipping clutch
☐
☐
3.4.5
Check function and tight fit of cable for drive-up ramps
☐
☐
3.4.6
Check for sluggishness, corrosion and deformation of cable and
☐
3.4.7
Check the preservation of the bearings and moving parts, if
necessary spray the areas with preservative.
K2
☐
3.5
Platform
3.5.1
Check for corrosion, chipping, noise, wear and deformation.
☐
☐
3.5.2
Check position, function, fastening, tight fit and lubricate bearing
S1 / S2 / S3
☐
☐
3.5.3
Check function and tight fit of platform motor
☐
☐
3.5.4
Check the preservation of bearings and moving parts, if necessary
spray the areas with preservative.
K2
☐
3.6
Drive-up ramps
3.6.1
Check for corrosion, noises and deformations.
☐
☐