Page 16
490X Engineer’s Reference Guide
In conclusion, the Yes and No Keys are used to navigate. The No Key is also used to
change a value (may also require a numeric input) and the Zero Key is used to move
back a level (not when display is expecting a numeric input)
If you are confident in programming the 490X Control Panel please use the headers
and options above to continue
Otherwise
Please continue with the next section for a Step by Step Guide to programming the
490X Control Panel.
Only the major options will be covered in the Step by Step sections. After
completing the sections you should be confident to program the remaining
options.
Headers & Options
Service
Service Timer / PTM
Time To Next Service
Service Tel No.
Lock-Out On/Off
Engineer Mode Constant/Timed
Custom Screens
LCD Status Display
LED Status Display
Diagnostics / Log
List Event Log
Change List Diagnostics
Headers & Options
Alarm Confirm
Window Time
On Entry
Sounder Mode
Reset Mode
Secondary Time
ET Mode
Bell Mode
Strobe Mode
Start Delay
Comms Restore
Keypad Opening
490X 1.qxd 11/07/2006 12:32 Page 16
To Next Page
Loading...
