GARDTEC GT490X - Common Options with Menu Numbers

Common Options with Menu Numbers
You are able to jump to various common options when programming by entering the
relevant menu numbers. With a Header showing, key in the appropriate menu number,
then press Yes.
Page 17
490X Engineer’s Reference Guide
Menu Jumps to
1 PGM 1 Output
2 Timer 1 On Time
4 Timer 1 Off Time
6 PA Mode
8 Chime Level
9 Entry Exit Level
10 Exit Sounder Mode
11 Final Set Delay
12 Full Set Setting Time / Setting Mode
13 Part 1 Set Setting Time / Setting Mode
14 Part 2 Set Setting Time / Setting Mode
15 Part 3 Set Setting Time / Setting Mode
20 Alert 1 Keys Mode / On Off
21 Alert 2 Keys Mode / On Off
22 Install Keypads
23 Bell Delay / No. of Bell Arms
24 Bell Ring Time / Sounder Mode
26 NovActive On Off
27 Bell Tamper Ring On Off
28 Entry Time 1
29 Entry Time 2 / Warning Bell
30 Fire Zone Delay
34 Digicom Type
35 Key Beep Level
37 Zone Re-Arm / Double Knock Time
38 Engineer Code
40 Line Fault Sounders
41 Line Fault Mode
42 Line Fault Log
44 PGM 1 Output
46 Main Fail Delay
47 Tamper Reset Mode
48 Backlight Mode
50 Zone Response
51 Zone Types
52 Test Zone (Attributes)
53 Save Panel NVM to PTM / Service Timer
54 Service Due Weeks
55 Zone Log Limit
58 Digicom Channels
64 Alarm Restore / Abort Time
65 Test Digicom Channels
66 E/E Zones in Part Set
67 Engineer Code Locked / Unlocked
68 Strobe Confirm
Menu Jumps to
69 Auto Part Set
70 Part Set Bells
71 Zone Types ( Enter Zones)
72 On Board Pairing
75 Program Zone Wiring
92 LCD Status
97 List Event Log
131 NovActive
139 PSU Test Time
153 Test Zones
155 Confirm Time Window (DD243 Section)
156 Secondary Time Window
157 Confirm on Entry On Off
158 Sounder Trigger
159 Unconfirm Reset Mode
160 E/T Mode
161 Bell Trigger
162 Confirm Start Delay
164 Strobe Timer
165 Strobe Trigger
166 Custom 1 OP Mode
167 Custom 2 OP Mode
168 Custom 3 OP Mode
169 Custom 4 OP Mode
170 Custom 5 OP Mode
171 Custom 6 OP Mode
172 Custom 7 OP Mode
173 Custom 8 OP Mode
174 Comms Restore On Off
490X 1.qxd 11/07/2006 12:32 Page 17