GARDTEC GT490X - Programming Diagnostics; Log

Page 76
490X Engineer’s Reference Guide
Programming Diagnostics / Log
The 490X control panel has some limited diagnostic features available to the engineer.
To access these proceed as follows.
1) Enter into Engineer Mode
To do this follow Steps 1 to 4 on page 18
With the display showing:-
2) Press No fifteen times. The display will show:-
3) Press Yes. The display will show:-
4) Press Yes if you wish to view the Event Log
The display will show for example:-
This is the last event in the Log
Use the No key to move backward in the Log
Use the Yes key to move forward in the Log
5) When you have finished viewing the Log press
0 (zero). The display will show:-
Program . . . . _ _ _
Zones ?
Program . . . . _ _ _
Diagnostics / Log ?
Program . . . . _ _ _
Diagnostics / Log ?
List
Event Log ?
Eng Code
01 Jan 01:18:12
490X 1.qxd 11/07/2006 12:32 Page 76