GARDTEC GT490X - Programming Point ID & SIA Protocols

Page 91
490X Engineer’s Reference Guide
Programming Point ID & SIA Protocols
1) Enter into Engineer Mode
To do this follow Steps 1 to 4 on page 18
With the display showing:-
2) Press No five times. The display will show:-
3) Press Yes. The display will show:-
4) Press Yes. The display will show, for example:-
5) Press No until the display shows:-
Or:-
As required
6) Press Yes. The display will show:-
7) Press No until the setting you require is displayed.
Then press Yes. The display will show:-
8) Press No. The display will show:-
9) Press No. The display will show:-
10) Press Yes. The display will show:-
Program . . . . _ _ _
Zones ?
Program . . . . _ _ _
Digicom ?
Program Digicom
Type or Test
Program Digicom
Type or Test
Program Digicom
Delay / Part ?
Program
Triggers ?
Digicom Type . . . .
= Mod + FF
Digicom Type . . . .
= Mod + PID
Digicom Type . . . .
= Mod + SIA
VoComm
=Off
Program Digicom
Channels ?
490X 1.qxd 11/07/2006 12:32 Page 91