Page 43
490X Engineer’s Reference Guide
20) Press No. The display will show:-
21) Press Yes. The display will show:-
With the Bell Tamper Ring On tampering the Bell Box will also trigger the Bell
Output from the control panel. With Bell Tamper Ring of the Bell Trigger from the
panel is not activated.
22) Press No until your required setting is displayed
then press Yes. The display will show:-
23) Press No. The display will show:-
24) Press Yes. The display will show:-
25) Press No until the required setting is displayed
then press Yes. The display will show:-
26) This concludes the programming for
Bells & Sounders. Press 0 (zero) to return to:-
Or
Press 0 (zero) until the display shows:-
Program Bell
Tamper Mode ?
Program Bell
Tamper Mode ?
Program Bell
for Part-Set ?
Program Bell
for Part-Set ?
Part-Set Bells
= On
Bell Tamper Ring
= On
Program . . . . _ _ _
Bells / Sounders ?
01 Jan 00: 00: 01
490X 1.qxd 11/07/2006 12:32 Page 43
To Next Page
Loading...
