Finding a Geocache with a chirp
1 With chirp searching enabled, navigate to a geocache.
When you are within approximately 10 m (33 ft.) of the geocache that contains a chirp, details about the
chirp appear.
2 Select Show chirp Details.
3 If necessary, select Go to navigate to the next stage of the geocache.
Logging the Attempt
Before you can log an attempt to find a geocache, you must start navigating to the geocache (Navigating to a
Geocache, page 13).
After attempting to find a geocache, you can log your results.
1 Select Geocaching > .
2 Select Found, Did Not Find, Needs Repair, or Unattempted.
3 Select an option:
• To begin navigation to the next geocache nearest you, select Find Next Closest.
• To stop logging, select Done.
• To enter a comment about looking for the cache or about the cache itself, select Edit Comment, enter a
comment, and select .
Applications
Sending and Receiving Data Wirelessly
Before you can share data wirelessly, you must be within 10 feet (3 m) of a compatible device.
Your device can send and receive data when paired with another compatible device using ANT+
®
wireless
technology. You can share waypoints, geocaches, routes, and tracks.
NOTE: This feature is not available for the eTrex Touch 25 device.
1 Select Share Wirelessly.
2 Select an option:
• Select Send, and select a type of data.
• Select Receive to receive data from another device. The other compatible device must be attempting to
send data.
3 Follow the on-screen instructions.
Setting a Proximity Alarm
Proximity alarms alert you when you are within a specified range of a particular location.
1 Select Proximity Alarms > Create Alarm.
2 Select a category.
3 Select a location.
4 Select Use.
5 Enter a radius, and select .
When you enter an area with a proximity alarm, the device sounds a tone.
Calculating the Size of an Area
1 Select Area Calculation > Start.
2 Walk around the perimeter of the area you want to calculate.
3 Select Calculate when finished.
14 Applications
To Next Page