Garmin G1000 Pilot’s Guide for the Diamond DA42NG
190-00962-04 Rev. Aiv
WARNINGS, CAUTIONS, AND NOTES
NOTE: Operating the system in the vicinity of metal buildings, metal structures, or electromagnetic fields
can cause sensor differences that may result in nuisance miscompare annunciations during start up, shut
down, or while taxiing. If one or more of the sensed values are unavailable, the annunciation indicates no
comparison is possible.
NOTE: The system responds to a terminal procedure based on data coded within that procedure in the
Navigation Database. Differences in system operation may be observed among similar types of procedures
due to differences in the Navigation Database coding specific to each procedure.
NOTE
: The FAA has asked Garmin to remind pilots who fly with Garmin database-dependent avionics of the
following:
• It is the pilot’s responsibility to remain familiar with all FAA regulatory and advisory guidance and information
related to the use of databases in the National Airspace System.
• Garmin equipment will only recognize and use databases that are obtained from Garmin or Jeppesen. Databases
obtained from Garmin or Jeppesen are assured compliance with all data quality requirements (DQRs) by virtue
of a Type 2 Letter of Authorization (LOA) from the FAA. A copy of the Type 2 LOA is available for each database
and can be viewed at http://fly.garmin.com by selecting ‘Type 2 LOA Status.’
• Use of a current Garmin or Jeppesen database in your Garmin equipment is required for compliance with
established FAA regulatory guidance, but does not constitute authorization to fly any and all terminal procedures
that may be presented by the system. It is the pilot’s responsibility to operate in accordance with established
AFM(S) and regulatory guidance or limitations as applicable to the pilot, the aircraft, and installed equipment.
NOTE
: The pilot/operator must review and be familiar with Garmin’s database exclusion list as discussed in
SAIB CE-14-04 to determine what data may be incomplete. The database exclusion list can be viewed at
www.flygarmin.com by selecting ‘Database Exclusions List.’
NOTE
: The pilot/operator must have access to Garmin and Jeppesen database alerts and consider their
impact on the intended aircraft operation. The database alerts can be viewed at www.flygarmin.com by
selecting ‘Aviation Database Alerts.’
NOTE
: If the pilot/operator wants or needs to adjust the database, contact Garmin Product Support to
coordinate the revised DQRs.
NOTE: Garmin requests the flight crew report any observed discrepancies related to database information.
These discrepancies could come in the form of an incorrect procedure; incorrectly identified terrain, obstacles
and fixes; or any other displayed item used for navigation or communication in the air or on the ground. Go
to FlyGarmin.com and select ‘Aviation Data Error Report’.
To Next Page
Loading...
Need help?
General
