Garmin G5 - Page 19

Garmin G5 User's Manual
190-02072-00 Rev. B 7
Installation Manual
Installation Manual Pilot's Guide Index
1.2.2.1 WIRING HARNESS INSTALLATION
Use cable meeting the applicable aviation regulation for the interconnect wiring.
Any cable meeting specifications is acceptable for the installation. When routing
cables, observe the following precautions:
• Allcableroutingshouldbekeptasshortandasdirectaspossible.
• Checkthatthereisamplespaceforthecablingandmatingconnectors.
• Avoidsharpbendsincabling.
• Avoidroutingnearaircraftcontrolcables.
• Avoidroutingcablesnearheatsources,RFsources,EMIinterferencesources,
powersources(e.g.400Hzgenerators,trimmotors,etc.)ornearpowerfor
uorescentlighting.
• RoutetheGPSantennacableasfaraspossibleawayfromallCOM
transceiversandotherantennacables.
The installer shall supply and fabricate all of the cables. Electrical connections
are made through the D subminiature connector. Section 1.5 defines the electrical
characteristics of all input and output signals. Required connectors and associated
hardware are supplied with the connector kit.
Contacts for the connectors must be crimped onto the individual wires of the aircraft
wiring harness.
Table 1-2 lists contact part numbers (for reference) and recommended crimp tools.
CAUTION: Check wiring connections for errors before connecting any wiring
harnesses. Incorrect wiring could cause internal component damage.