Garmin G5 - 1.7 G5 Configuration and Post Installation Checkout

Garmin G5 User's Manual
190-02072-00 Rev. B 35
Installation Manual
Installation Manual Pilot's Guide Index
1.7 G5 CONFIGURATION AND POST INSTALLATION
CHECKOUT
The checkout procedures in this section are recommended to be performed after
installing the G5. The calibration procedures are required to be performed after
installing the G5. It is assumed that the person performing these checks is familiar with
the aircraft, has a working knowledge of typical avionics systems, and has experience
using the test equipment defined in this section.
NOTE: See Section 2 Pilot's Guide for G5 operational instructions.
NOTE: Some procedures in this section require that the GPS receiver is receiving
sufficient satellite signal to compute a present position. This requires outdoor line-
of-site to GPS satellite signals or a GPS indoor repeater.
NOTE: As these procedures involve engine run-up and moving the aircraft, it
is recommended that the installer read this entire section before beginning the
checkout procedure.
NOTE: All test equipment should have current calibration records.
CAUTION: Be sure to check all aircraft control movements before flight is
attempted to ensure that the wiring harness does not touch any moving part.