Garmin GPSMAP 536 - Setting Alarms

52 GPSMAP 400/500 Series Owner’s Manual
Conguring the Chartplotter
Device List—lists the NMEA 2000 devices on your network. If a
NMEA 2000 device has conguration options or settings, select
the device for a list of options.
Label Devices
—allows you to name your engines and tanks so
that you can better identify their location on the boat.
To label engines as numbers:
From the Home screen, select Congure > Communications >
NMEA 2000 Setup > Label Devices > Change Engine Labels
> Use Numbers.
To label engines as names:
1. From the Home screen, select Congure > Communications >
NMEA 2000 Setup > Label Devices > Change Engine Labels
> Label Type > Choose Names.
2. Select the engine you want to name.
3. Select the location of the engine: Port (P), Center (C),
Starboard (S), Fore (F), or Aft (A).
4. Select the label you want to use for the engine.
To label tanks as numbers:
1. From the Home screen, select Congure > Communications >
NMEA 2000 Setup > Label Devices > Change Tank Labels.
2. Select the type of tank you want to label.
3. Select Use Numbers.
•
•
To label tanks as names:
1. From the Home screen, select Congure > Communications >
NMEA 2000 Setup > Label Devices > Change Tank Labels.
2. Select the type of tank you want to label.
3. Select Choose Names.
4. Select a tank.
5. Select the location of the tank: Port (P), Center (C), Starboard
(S), Fore (F), or Aft (A).
6. Select the label you want to use for the tank.
Setting Alarms
You can set the unit to sound an audible alarm when certain
conditions are met. By default, all alarms are turned off.
To set an alarm:
1. From the Home screen, select Congure > Alarms.
2. Select an alarm category.
3. Select an alarm.
4. Select On to turn on the alarm.
5. Specify alarm information.