Garmin GPSMAP 64s - Removing a Page; Altimeter Settings; Changing the Units of Measure; Time Settings


11111111 111111
. cp .







3 Select a page to add.

Removing a Page
1 From the main menu, select
Setup >
Page Sequence.
2
Select a page.
3
Select Remove.
4
Select ENTER.

Changing the Units of
Measure
You can customize units of measure
for
distance and speed , elevation,
depth, temperature, pressure and
vertical speed. '
1
Select Setup > Units.
2
Select a measurement type.
3
Select a unit of measure.

Time Settings
S lect Setup> Time Settings.
T1me Format:Sets the device to
show time in a 12-hour or 24-
hour format.
Time Zone:
Sets the time zone for
the
device. Automatic sets the
time
zone automatically based
on your GPS position.
Position Format Settings
NOTE:You should not change the
position format or the map datum
coordinate system unless you are
using a map or chart that specifies
a
different position format.
Select Setup > Position Format.
Position Format:
Sets the position
format in which a location
reading appears.
Map Datum:
Sets the coordinate
system on which the map is
structured.
Map Spheroid:Shows the
coordinate system the device
is
using. The default coordinate
system is WGS 84.

Altimeter Settings
Select Setup >Altimeter.
Auto Calibration:Automatically
calibrates the altimeter each
time the device is turned on.
Barometer
Mode : Variable
Elevation
allows the barometer
to measure changes in
elevation while you are moving.
Fixed Elevation
assumes the


40



. cp .