Garmin GPSMAP 67 - Map Management; Profile and Alarm Settings; Satellite Page; Satellite Status Information

Enabling Maps
You can enable map products installed on your device.
1 Select Map Manager > Outdoor Maps+ > MENU > Configure Maps.
2 Select the toggle switch to enable each installed map.
3 Select the map name to change the raster brightness level (optional).
Deleting a Map
You can remove maps to increase the available device storage.
1 Select Map Manager > Outdoor Maps+.
2 Select a map.
3 Select MENU > Delete.
Selecting a Profile
When you change activities, you can change the setup of the device by changing the profile.
1 Press MENU twice to open the main menu.
2 Select Profile Change.
NOTE: You may need to add this application to the main menu before you can select it (Customizing the Main
Menu, page40).
3 Select a profile.
Setting a Proximity Alarm
Proximity alarms alert you when you are within a specified range of a particular location.
1 Press MENU twice to open the main menu.
2 Select Proximity Alarms > Create Alarm.
NOTE: You may need to add this application to the main menu before you can select it (Customizing the Main
Menu, page40).
3 Select a category.
4 Select a location.
5 Select Use.
6 Enter a radius.
When you enter an area with a proximity alarm, the device sounds a tone.
Editing or Deleting a Proximity Alarm
1 Press MENU twice to open the main menu.
2 Select Proximity Alarms.
3 Select an alarm.
4 Select an option:
• To edit the radius, select Change Radius.
• To view the alarm on a map, select View Map.
• To delete the alarm, select Delete.
Satellite Page
The satellite page shows your current location, GPS accuracy, satellite locations, and signal strength.
You can select or to view additional satellite constellations when they are enabled.
Main Menu Tools 33