Garmin Instinct 2 Series User Manual

Changing the Spring Bar Bands
You can replace the bands with new Instinct 2 bands or compatible QuickFit
®
22 bands.
1 Use the pin tool to push in the watch pin.
2 Remove the band from the watch.
3 Select an option:
• To install Instinct 2 bands, align one side of the new band with the holes on the watch, push in the
exposed watch pin, and press the band into place.
NOTE: Make sure the band is secure. The watch pin should align with the holes on the watch.
• To install QuickFit 22 bands, remove the watch pin from the Instinct 2 band, replace the watch pin on the
watch, and press the new band into place.
NOTE: Make sure the band is secure. The latch should close over the watch pin.
4 Repeat the steps to change the other band.
Data Management
NOTE: The device is not compatible with Windows
®
95, 98, Me, Windows NT
®
, and Mac
®
OS 10.3 and earlier.
Device Information 95

Garmin Instinct 2 Series Specifications

General

Display Type	Monochrome, sunlight-visible, transflective memory-in-pixel (MIP)
Display Resolution	176 x 176 pixels
Lens Material	Chemically strengthened glass
Bezel Material	Fiber-reinforced polymer
Case Material	Fiber-reinforced polymer
Strap Material	Silicone
Water Rating	10 ATM
Memory/History	32 MB
Connectivity	Bluetooth, ANT+, Wi-Fi (varies by model)
Compatibility	iPhone, Android
Smart Notifications	Yes
Music Storage	No
Display Size	0.9” x 0.9” (23 x 23 mm)
QuickFit Watch Band Compatible	Yes
Weight	52 g
Sensors	GPS, GLONASS, Galileo, Barometric altimeter, Compass, Gyroscope, Accelerometer, Thermometer
Garmin Pay	Yes
Color Options	Graphite, Tidal Blue