232001840G(06)
4.1.2.1 Ethernet Connectivity Setup
GCC laser engraver is built-in with LAN port to transmit data from PC to laser engraver with ease and
higher speed instead of USB port option.
Step 1. Connect LAN cable to the LAN port of GCC laser engravers and turn on machine
Step 2. Navigate the control panel through <F4> FunctionÆ <Machine Setting>Æ <LAN Setup Wizard>Æ
DHCP: OFF.
Step 3. Navigate the control panel through <F4> FunctionÆ <Machine Setting>Æ <LAN Setup Wizard>Æ
IP Address.
Step 4. Enter 192,168,3.X (X refers to 1~255 value which can’t be the same value with IP address setting
in PC or Notebook) for IP, and 255.255.255.0 for MASK with UP/ DOWN keys.
To Next Page
Loading...
