GCC Technologies LaserPro C180II - Installation of the Laserpro Print Driver

37 232001840G(08)
4.2.2 Installation of the LaserPro Print Driver
1) Insert the LaserPro CD.
2) From the auto run menu, select C180II
ൺ 
LaserPro Driver to start the LaserPro Print Driver
installation.
3) When the Add Printer Wizard menu comes up, click Next to continue.
4) At the Local or Network Printer page, select <Local printer attached to this computer>, then click
Next to continue.
5) At the Select a Printer Port page, select <Use the following port> and select the port that the
LaserPro C180II will be attached to, then click Next to continue.
6) The next screen will prompt you with a list to select the manufacturer and model of your printer.
From this menu, click Have Disk. Another menu will now pop up for you to indicate the location of the
print driver. With the LaserPro CD still in your drive, click Browse and locate the GLxxx.inf file
on the installation CD(xxx are numbers representing the driver version). Click OPEN to have
C180II displayed as a valid printer.
7) Now select C180II from the list of printers (The C180II should be the only printer displayed on the list)
and click Next to continue.
8) If a screen comes up informing you of the detection of a previous driver and asks to keep the
existing driver or use the new one, select Replace Existing Driver and click Next to continue.
9) This screen will prompt you to provide a printer name. Simply type in <C180II> and select Yes or
No if you want to use this printer as the default printer and click Next to continue.
NOTE
When working with the LaserPro C180II Print Driver within your graphics software, you will
need to have the C180II set as the default printer to get proper output. If you select to not
have the C180II be the default printer, please remember to manually change this on your
own from within the graphic software printer selection area or from the Windows Control
Panel
→
Printers and Faxes section.
10) At the Printer Sharing screen, select <Do not share this printer> and click Next to continue.
11) Select <No> when asked if you want to print a test page and click Next to continue.
12) Now simply click Finish to complete the Add Printer Wizard.
13) Now the installation will proceed, if you get a Hardware Warning about the software you are
installing for this hardware has not passed Windows Logo testing… simply click Continue Anyway to
ignore this warning.
14) Congratulations, your printer driver has been successfully installed!