GE 60-960-95 - Set Up Schedules Menu; Arming (0660 nn, where nn=Schedule number [0 to 15])

Concord Ultra 60
Attach Schedules to Events Menu
The ATTACH SCHEDULES TO EVENTS menu lets you link the following system events to time
schedules:
• Latchkey Opening—sends a report if system is disarmed within the attached time schedule.
• Latchkey Closing—sends a report if system is armed within the attached time schedule.
• Exception Opening—sends a report if system is not disarmed within the attached time
schedule.
• Exception Closing—sends a report if system is not armed within the attached time sched-
ule.
• Lights (1–9) activate X10 controlled lights by the attached time schedule.
• Outputs (1–6) allow users to attach onboard (1–2) and SnapCard outputs to a schedule.
• Arming—Allows the user to arm the panel at the schedule start time.
Set Up Schedules (05XXY, where
XX=schedule 00 thru 15 and
Y=start [0]/stop[1] 0 thru 8-Mon-
day thru Sunday [2-8])
(Default = 00:00)
This menu lets you set up start/stop times for
each day of the week.
Note
If you are programming schedules for your cus-
tomer, be sure to record the settings in the
User’s Manual
¾To set up a Time Schedule:
1. Press A or B until the display shows SET UP SCHEDULES.
2. Press # and the display shows
SCHEDULE 00. If you want a different sched-
ule number, press A or B until the desired schedule number appears.
3. Press # and the display shows
START TIME hh:mm (current setting).
4. Enter the desired starting time (00:00–23:59). The display flashes the
entered time. Press # and the display shows
START TIME hh:mm (new setting).
5. Press B and the display shows
STOP TIME hh:mm (current setting).
6. Enter the desired stop time (00:00–23:59). The display flashes the entered
time. Press # and the display shows
STOP TIME hh:mm (new setting).
7. Press B and the display shows
MONDAY OFF/ON (current setting). To select
a different day, continue pressing B until the desired day appears.
8. Press 1 (off) or 2 (on). The display flashes the entered selection.
9. Press # and the display shows the new setting for the selected day.
10. Repeat steps 7 and 8 until all desired settings for each day are set.
Latchkey Reports (060nn-Open-
ing, 061nn-Closing, where
nn=Schedule number [0 to 15])
Attach Schedules To Events (Default = off)
This setting lets you attach the Latchkey
Opening report feature and the Latchkey
Closing report feature to time schedules.
Closing report feature to time schedules.
¾
To Attach a Schedule to Latchkey Opening or Latchkey Closing:
1. Press A or B until the display shows ATTACH SCHEDULES TO EVENTS.
2. Press # then A or B until the display shows LATCHKEY OPENING OR LATCH-
KEY CLOSING.
3. Press # and the display shows SCHEDULE 00 OFF/ON (current setting). If
you want a different schedule, press A or B until the desired schedule
appears.
4. Press 1 (off) or 2 (on). The display flashes the entered selection.
5. Press # and the display shows the new setting for the selected schedule.