GE B20 - Page 113

109
Changing the units
You can use %, kPa or mmHg as the CO
2
measurement units. The
units can be changed in the CO2 Setup menu:
1. Press the
Airway Gas key.
2. Select CO2 Setup - Unit.
3. Choose the option.
Selecting the source of respiration
You can select the respiration rate’s source
1. Press the Airway Gas key.
2. Select CO2 Setup - Resp Rate Source.
3. Choose the option.
NOTE: If you select AUTO, the rate is calculated from the measured
CO
2
.
OFF/ON the CO
2
measurement
1. Press the Airway Gas key.
2. Select CO2 Setup - Measurement.
3. Choose OFF or ON
Setting alarms
Setting CO
2
alarms
1. Press the
Airway Gas key.
2. Select CO2 Setup - CO2 Alarm.
3. Select Adjust Limits to set up the limits.
4. Select EtCO2 Alarm, FiCO2 Alarm to OFF/ON the limits.
5. You can also select Alarms Setup to adjust CO
2
or related
alarms.
Setting respiration rate alarms
1. Press the
Airway Gas key.
2. Select CO2 Setup - Resp Rate Alarm.
3. Select Adjust Limits to set up the limits.
4. Select RR Alarm, to OFF/ON the limits.
5. You can also select Alarms Setup to adjust RR or related alarms.