34
Setting time and date
NOTE: If the monitor is connected to the central station, it follows the
central station's time settings and the Time and Date menu is not
available.
NOTE: You cannot change the monitor's time settings after the
patient has been admitted.
1. Press Monitor Setup and select Time and Date
2. Turn and push the Trim Knob to set the time and date.
Battery setup
Through this menu, you can check the battery status:
1. Press the Monitor Setup key.
2. Select Battery Setup. Battery information is now available.
Changing the monitor installation settings
Changing unit
You can change units for height, weight and blood pressure.
1. Press
Monitor Setup key.
2. Select Install/Service and enter the password.
3. Select Installation - Units
4. Set the units for height, weight and blood pressure.
You can change temperature units through Others - Temp Setup
and CO
2
units through Airway Gas - CO2 Setup. The changes are
permanent.
To Next Page
Loading...
