GE B20 - Ending monitoring

49
Saving data
The monitor continuously saves patient data, such as trends. Saving
is activated once the patient is admitted. The monitor saves
automatically:
− In the monitor memory the most recent patient data up to 72
hours.
− In the network the most recent patient data up to 2 to 90 days in
central station depending on the configuration.
Ending monitoring
1. Print necessary data: press the Print/Record key.
2. Wait until the printing is finished. Then clear the patient data and
return the settings, including alarm limits, to their defaults
through Admit/Discharge - Discharge - YES
3. Turn off the monitor from the
ON/OFF key if the monitor will not
be used.
NOTE: A message “Monitor is shutting down...“ will be on the
screen.
4. Clean the monitor according to the instructions.
NOTE: When discharge patient, don’t do any action until the “Patient
dischanged” message appeared.