GE MEDICAL SYSTEMS CT9800 QUICK SYSTEM
Rev. 16 Direction 18000
4-10-8
Command? FULL ‘CR’
Command destroys any previous RDOS disk structure
RDOS INIT/F must be done on the disk after the command
Type CONTROL-A now to abort without loss
Do you want a co-resident diagnostic area? NO ‘CR’
Number of patterns to run (1-5)? 1 ‘CR’ (Argus) 5 ‘CR’ (Zebra)
(For Argus) (For Zebra)
*** PATTERN #1 (022445) *** *** PATTERN #1 (052525) ***
*** PATTERN #2 (066266) ***
*** PATTERN #3 (155555) ***
*** PATTERN #4 (133333) ***
*** PATTERN #5 (054306) ***
Do you wish to declare any blocks bad (Answer NO ‘CR’. If any additional
that are not already in the bad block table? blocks are known to be bad, answer
YES ‘CR’ and add them to the list)
Default REMAP AREA size is 126 block(s)long
it needs to be at least 9 block(s) long
REMAP AREA size (type RETURN for default)? ‘CR’
REMAP AREA start block number (type RETURN) for default)? ‘CR’
DEFAULT FRAME size is 137,
min is 1, and max is 1572
Disk FRAME size (type RETURN for default)? ‘CR’
Full DISK INIT Complete
Command? LIST ‘CR’
On unit DA0: 6236 (DAn) 14” sealed Moving Head Disk 354 MB (For primary
ARGUS)
On unit DA1: 6236 (Dan) 14” sealed Moving Head Disk 354 MB (For secondary
ARGUS)
On unit DZ0: 6061 (DZn) Top loading pack, 11 platters 192 MB (For primary
ZEBRA)
On unit DZ1: 6061 (DZn) Top loading pack, 11 platters 192 MB (For secondary
ZEBRA)
FRAME size = 137 REMAP size = 176
REMAP AREA start block number = 00002506542
Number of bad blocks = 4
To Next Page
Loading...
