GE CT-9800

GE MEDICAL SYSTEMS CT 9800 QUICK SYSTEM
Rev. 14 Direction 18000
4-3-30
TABLE 4-3-2
SCSI MODULE ERROR CODES
CODE
TEST
POSSIBLE FAILURE
1
RESERVED
2
DYNAMIC RAM TEST
Data read from the dynamic RAM did not compare with data
written.
3
BMC DATA BUFFER
Data read from the BMC data buffer did not compare with data
written.
4
DUAL PORT RAM
Data read from dual port ram did not compare with data written.
5
5380 SCSI IC
Data read from 5380 register did not compare with data written, or
a forced 5380 interrupt was not detected.
6
DYNAMIC RAM
PARITY
DRAM parity error interrupt not successfully forced or cleared.
7
NOT USED
8
NOT USED
Operational Errors:
Some error conditions may occur while the board is executing M level programs. These errors will be reported on
the Left RED LED. The error codes are listed in Table 4-3-3. The error can be cleared by rebooting the
Computer.
TABLE 4-3-3
SCSI MODULE ERROR CODE
CODE
ERROR
9
BMC Data Buffer Parity Error
10
Dynamic RAM Parity Error
11
Illegal Interrupt From Host Side
Note: Codes 9, 10, & 11 indicate possible hardware problems on the controller board.