DigitalFlow™ GF868 Startup Guide (1 and 2-Channel) 29
Chapter 2. Initial Setup
2.6.6a Further Options
After completing the above steps, the meter returns to the User (or Channel) PROGRAM prompt. Continue as follows:
• To continue programming the meter, refer to the menu maps in Appendix A of the Programming Manual and
navigate to the desired menu. Then, proceed to the appropriate section of the manual for instructions.
• To leave the User Program and retain the previous settings, press [EXIT] once (for a 1-channel GF868) or twice (for
a 2-channel GF868) and then press
[F1] = NO at the SAVE prompt. Any programming changes will be discarded and
you will be returned to the data display.
• To leave the User Program and return to measurement mode, press [EXIT] once (for a 1-channel GF868) or twice
(for a 2-channel GF868) and then press
[F2] = YES at the SAVE prompt. Your programming changes will be entered
into the meter’s memory, and you will be returned to the data display.
Note: See the Programming Manual for instructions on using the SAVE submenu.
Proceed to Chapter 3, Operation, for instructions on taking measurements or refer to the Programming Manual for
instructions on programming the Model GF868’s advanced features.
To Next Page
Loading...
Need help?
General
