Appendix C. Optional Enclosures
54 DigitalFlow™ GF868 Startup Guide (1 and 2-Channel)
C.3 Rack Mount Wiring (cont.)
3. Wire the 0/4-20 mA analog outputs at the left side of the rear panel in accordance with the instructions in Chapter
1, Installation, of this manual.
4. Wire the RS232 serial port by completing the following steps:
a. Purchase or prepare a suitable serial cable. This cable should have a standard female DB9 connector, wired as
shown in Figure 15 on page 56, for connection to the rear panel of the Model GF868. The other end should be
as required for the external device.
b. Complete the serial port wiring in accordance with the instructions in Chapter 1, Installation, of this manual.
5. Wire any installed option cards using the same procedures described in Chapter 1, Installation, of this manual and
the pin # assignments shown in Figure 15 on page 56.
6. Place the power switch (item #1) in the ON position.
The Model GF868 is now completely wired. Proceed to Chapter 2, Initial Setup, of this manual for further instructions.
C.4 Rack Mount Front Panel
The keypad and LCD display for the rack mount Model GF868 are located on the front panel. These items are identical
in form and function to those used on the standard Type-4X enclosure, but the layout is somewhat different.
Refer to Figure 16 on page 57 for the front panel layout of the rack mount Model GF868 and follow the standard
procedures detailed in the main body of this manual.
To Next Page
Loading...
Need help?
General
