Chapter 3. Operation
50 DigitalFlow™ XGM868i Startup Guide
3.5.3 PanaView Display
Power up PanaView, establish communications with the XGM868i and enter the required startup parameters, as
described in Chapter 2, Initial Setup. Then, proceed as follows:
Note: See Chapter 2, Initial Setup, in this manual and/or Chapter 1, Programming Site Data, in the Programming
Manual for complete instructions on entering startup data via PanaView.
1. In PanaView, pull down the Output menu, as shown in Figure 18, and click on the Text Display option.
Figure 18: The Output Menu
Note: The Text Display window that appears after Step 1 is actually stacked on top of any previously opened
windows (such as the Meter Browser window).
2. Using the Window menu, as described in the PanaView User’s Manual, arrange the open windows in the desired
format. For this discussion, Figure 19 shows the Text Display window in its maximized (full-screen) size.
Figure 19: The Text Display Window
3. The left pane of the Text Display window contains the standard PanaView network tree. Expand the XGM branch,
and double-click on the desired channel. (On 2-channel units, you can also display the SUM, DIFF or AVG
parameters.)
To Next Page
Loading...
