DigitalFlow™ XGM868i Startup Guide 65
Appendix B. Data Records
B.3 Setup Data
After the Model XGM868i flow transmitter has been installed, setup data must be entered via the User Program prior
to operation. Record that information in Table 16 below.
Table 16: Setup Data
General Information
Model # Serial #
Software Vers. Setup Date
Channel - Status
Channel 1 Channel 2
Channel Status Off Burst Channel Status Off Burst
Measure Mode Skan S/M Measure Mode Skan S/M
Channel - System
Channel Label Channel Label
Site/Channel Msg.
Channel Message
Vol. Units Vol. Units
Vol. Time Units Vol. Time Units
Vol. Dec. Digits Vol. Dec. Digits
Totalizer Units Totalizer Units
Tot. Dec. Digits Tot. Dec. Digits
Mass Flow Mass Flow
Mass Flow Time Mass Flow Time
MDOT Dec. Dig. MDOT Dec. Dig.
Mass Totalizer Mass Totalizer
Mass Dec. Dig. Mass Dec. Dig.
Channel - Pipe Parameters
Channel 1 Channel 2
Trans. Type STD SPEC Trans. Type STD SPEC
Transducer # Transducer #
Spec. Trans. Freq. Spec. Trans. Hz
Spec. Trans. Tw Spec. Trans. Tw
Pipe O.D. Pipe O.D.
Pipe Wall Pipe Wall
Path Length (P) Path Length (P)
Axial Length (L) Axial Length (L)
Fluid Type Air Other Fluid Type Air Other
Other/Sndspd Other/Sndspd
Calibration Factor Calibration Factor
To Next Page
Loading...
Need help?
General
