Chapter 2. Initial Setup
34 DigitalFlow™ XMT868i Startup Guide
2.4 Entering Data in the Channel Menu
The Channel menu is used to enter data specific to each channel. Refer to Figure 14 on page 45 and remember to
record all programming data in Appendix B, Data Records.
Note: In this manual, only the programming of Channel 1 will be described. To program Channel 2 of a 2-Channel
meter, simply repeat the same procedures presented for Channel 1.
2.4.1 Selecting the Channel Measurement Method
The ACTIV submenu permits selection of the desired measurement method.
1. In the Keypad Program, scroll to
PROG and press [Enter].
2. In the
PROG menu, scroll to the desired channel (CH1 or CH2) and press [Enter].
Note: In the 1-Channel XMT868i, CH2 does not appear.
3. In the
Channel PROGRAM menu, scroll to ACTIV and press [Enter].
4. The option offers two choices:
OFF and TRANS (Transit-Time). Scroll to the desired option for this channel
and press
[Enter].
Note: In the 1-Channel XMT868i,
OFF does not appear.
The XMT868i returns to the
Channel PROGRAM menu. Scroll to the SYSTM option.
To Next Page
Loading...
