3 K0430 Issue No. 2
OPERATOR CONTROLS (Figure 1 and 2)
These divide into two groups, the operator/display controls (Figure 1) and the pressure/
vacuum generation components (Figure 2). The operator controls and a typical display,
common to all instrument versions, is shown below.
1 Display 2 Electrical Measurement Input Sockets 3 Cursor Keys
4 Enter Key 5 Function (soft) Keys 6 Hard Keys 7 On/Off Key
Figure 1 - DPI 610/615 IS Key-pad
DISPLAY
The display and key-pad of the instrument divides into four distinct sections. The two
main sections of the display are used to show an input and an output. The remaining
two sections show the status display area and define the soft key functions. A typical
display is shown below:
PRESSURE INT
bar
VOLTAGE V
F2F1
2
3
4
5
7
6
1
CURRENT
PRESSURE
UNITS
max 30V
TASK: BASIC
DPI 615 IS
PRESSURE INT
bar
VOLTAGE
V
CURRENT
UNITS
PRESSURE
TASK: BASIC
+
-
Input display
Output display
Soft boxes
Status display
INTRODUCTION Summary of Functions
To Next Page
Loading...
