K0430 Issue No. 2 20
Process Functions
If required, the following process functions are available on the input display but only in
ADVANCED task. If the instrument is in any other mode i.e. BASIC or any other task
mode, the input and output displays must first be configured in ADVANCED task.
Note: PROCESS functions are not available to the output channel.
A summary of the process functions follows.
• Tare Allows either the current display value or a manually
entered value to be tared off display parameter reading.
• Max/Min Displays running Max/Min and present display values
simultaneously. Resettable via F1 key.
• Filter Applies low pass filter function to displayed parameter.
Filter characteristics (Settling time and Band) are user
programmable.
• Flow Applies square root function to displayed parameter.
• % Span Converts displayed parameter reading to a percentage of
span. Span definable via the F1 key.
Following selection of ADVANCED from the task menu, press the INPUT key. Use the up
or down cursor keys to select the required input. Press the PROCESS (F1) key and
use the left or right cursor keys to enable the process on/off:
Press ENTER to switch the process ON with existing settings or F1 to change process
settings (where applicable).
Advanced Task Process Functions
To Next Page
Loading...
