25 K0430 Issue No. 2
mA Step
To select one of the electrical output programs, press the OUTPUT key and proceed as
follows:
On selection of (e.g.) Linear, the output display window changes to show the selected
program of output currents:
• Connect an external power source as shown on page 24.
•Press RUN (F1) to run program. A flashing status display CHECK LOOP indicates a
fault in the external loop i.e. supply fault or open circuit.
Note: The dwell time at each step is approximately 10 seconds.
•Press STOP (F1) when running to stop at any point. Press RUN (F1) to resume.
Advanced Task Select Output
To Next Page
Loading...
