GE J2S968 User Manual

Usingthe clock, timer andcontrol lockout, vvvvw.GEAppliances.com
Make sure the clock is set to the
correct time of da,¢
ToSet the Clock
The clock must be set to the correct time
of day fin" the autonmfic oven tinting
flmctions to work i)roperly. The time ot
day cannot be changed during a timed
baking or self=cleaning cycle,
[] Touch the CLOCK pad.
[] Touch the number pads.
[] Touch the START pad.
[]
Thetimer is a mhTutetimer onl_¢
Thetimer does not control oven
operations. The maximum setting on
the timer is 9hours and 59mhTutes.
ToSet the Timer
[]
Touch the KITCHEN TIMER
ON/OFFpad.
Touch the nmnber pads tmfil the
_liilOtlnt of time yell W_lIlt shows
in the displa): For example, to set
2 hom_ and 45 minutes, much 2, 4[
and 5 in that order: If wm make a
mistnke touch the KITCHEN TIMER
ON/OFF pad and begin again.
Touch the STARTpad.
AftertouchingtheSTARTpad, SETdisappears,
thistellsyouthetl_neis countingdown,although
thedisplaydoesnotchangeuntiloneminutehas
passedSecondswi//notbeshownin thedisplay
untilthe/astmlnuteiscountingdown.
[] _'_ hen tile timer reaches :00, tile
control will beep 3 times fi_llowed
by one beep eveI T 6 seconds until
the KITCHENTIMERON/OFFpad
is touched.
The6-secondtonecanbecance/edbyfo//owlbg
thestepsin theSpecialfeaturesofyouroven
controlsectionunderTonesat theEndeta
TimedCycle.
To Reset the Timer
If tile display is still showing tile time
remaining, you may change it by
touching the KITCHEN TIMER ON/OFF pad,
then touch tile number pads tmtil tile
time w)u want appea_ in tile display.
If tile remaining time is not in tile display
(clock, delay stnrt or cooking time are in
the display), recall the remaining time by
touching tile KITCHEN TIMER ON/OFFpad
and then touching tile nmnber pads to
enter tile new tiille veil iV_lilt,
ToCancel the Timer
Touch the KITCHENTIMERON/OFF
pad twice.
LOCK/UNLOCK HOLD 3 SECONDS
Control Lockout
Yourcontrolwill allowyoutolockout thetouch
padsso theycannotbeactivatedwhenpressed
To lo(k/tmlock tile controls:
[] Touch tile 9 and Opads at tile same
time fin 3 seconds, tmtil tile displa)
sho_:sLOCON.
[] To unlock tile control, touch tile 9
and 0pads at tile same time fin" 3
seconds, until the display shows
LOCOFF.
When this teatm'e is on and tile touch
pads are touched, tile control will beep
and tile display will show LOC ON.
Thecontrol/ockoutmode affects a// touch
pads. No touch pads wi// work when this
featureis activated
Theadjustment will be retained in memory
after a power fai/ure.
13

GE J2S968 Specifications

General

Brand	GE
Model	J2S968
Category	Ranges
Language	English