www.GEAppliances.com
Possih/eCaose
Control signals after You forgot to enter a
entering cooking time bake temperature or
or start time cleaning time.
What To Do
• Touch the BAKE pad and desired temperature or
the SELF CLEAN LO/STD pad and desired clean time.
Display goes blank A fuse in your home may be • Replace tile fl/se or reset tile circuit breaker:
blown or the circuit
breaker tripped.
The clock is in the • See the Special features of your oven control section.
black-out mode.
Display flashes Power failure. • Reset the clock.
Unable to get the Oven control pads were • The BROIL HI/LO and BAKE pads must be touched at
displayto show "SF" not touched properly, the same time and held fo_ 3 seconds.
"Probe" appears in This is reminding you to • Enter a probe teml_eratm'e.
the display enter a probe temperature
(on some models) after plugging in the probe.
Power outage, Power outage or surge. • Reset the clock. ]f the oven was in use you must reset
clock flashes it by touching the CLEAR/OFFpad, setting the dock
and resetting any cooking fiuactiou.
Steam from the vent When using the convection • This is normal.
feature, it is normal to see
steam coming out of the oven
vent. As the number of racks
or amount of food being
cooked increases, the amount
of visible stemn will increase.
"Burning" or "oily"
odoremittingfrom
the vent
This is normal in a new oven • To speed the process, set a self-clean cycle for a
and will disappem" in time. u]inimum of 3 hours. See the Using the self-cleaning
oxei] se('tioi],
Strongodor
An odor from the insulation • This is temporai T.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise
A cooling fan or a convection
fan (depending on the
function you are using) may
automatically turn on mad off.
• This is normal. The cooling tim will tm'n off and on
to cool internal parts. It may run after the oven is
tin'ned OFF, The convection fan will cycle on and off.
until the flu]ction is over or the door is opened.
39